KR285C rotary drilling rig Malaysian quartzite construction


Release time:

2021-08-05

The construction site of this project is in Malaysia. The geological structure of the project is relatively complex. It is necessary to drill 80Mpa quartzite at the bottom of the hole. The TYSIM Machinery 285 rotary drilling rig has completed the task excellently, and its good control and construction performance have been recognized by customers.

Construction video of TYSIM KR285C rotary drilling rig: https://v.qq.com/x/page/e0539tm9wqa.html
 
Spinner type: KR285C Large drilling depth: 88/57m
 
Large drilling diameter: 2300mm Output torque: 285kN.m
 
The construction site of this project is in Malaysia. The geological structure of the project is relatively complex. It is necessary to drill 80Mpa quartzite at the bottom of the hole. The TYSIM Machinery 285 rotary drilling rig has completed the task excellently, and its good control and construction performance have been recognized by customers.

 

A

 

TYSIM Machinery KR285C Rotary Drilling Rig
 
During the construction of this project, the geology is complicated, the hardness of quartzite reaches 80Mpa, the drill diameter is 1500mm, the depth of penetration is 8m, and it takes 14 hours to form the hole.
 
During the construction on the same site as the German Bauer BG36 rotary drilling rig, the customers were very satisfied with its good construction performance and praised the after-sales service of TYSIM Machinery.

 

A

Rotary drilling rigs from different manufacturers on the construction site

 

TYSIM KR285C rotary drilling rig adopts Caterpillar 336D widening chassis, structural parts adopt new-generation high-strength steel plate, and is equipped with the same electronic control system as a domestic brand manufacturer.

 

A

Rotary drilling bit used

 

A

Core taken out

 

A

Core taken out